Tool Changer for Kress/AMB FME1050/FME800-New Model!

ATC_KRESS_new model.jpg    
Product code: 14-0091

Weight: 0.613 Kg

€ 595,00

Στο παρόν προϊόν δεν ισχύει η αντικαταβολή.

VAT is not included (24%)

        Readily available - (Quantity: 1)
Show shipping cost estimation
Tool changer for AMB / Kress Spindle motor
This spindle is suitable for the AMB / Kress FME 1050 and FME 800. The assembly is quick and very simple. 
It is screwed onto the spindle shaft and attached to the spindle. 
Then you can fasten the "tool change spindle" just like the original 
Kress with the Euro 43mm mount.
The tool sits in a 
SK15 tool holder (in a ER11 collet) 
The SK15 Holder is held with spring force in the cone.
A pneumatic cylinder (air port 1)  presses the tool holder out of the cone.
With the air port 2 the integrated "blow-out" is  supplied (Air nozzle for cleaning 
the cone during the tool change)

  • Aluminum case 7075, hard-anodized
  • Stainless steel spindle
  • Double ball bearings (Hybrid-Ceramic-Spindellager von GMN, Güte P4, Typ HY S 61904 C TXM P4 UL)
  • Concentricity of 0.01 mm 
  • Weight 0.9 Kg
  • Tensile force of the spring 25 Kg
  • Uses SK15 Toolholders for ER11 Collets (1-8mm)
  • Operating pressure 8 bar
  • 2 pneumatic connectors for 4mm Tubing
  • Fastening with 43mm mount
  • Suitable for speeds up to 28,000 rpm
  • Spindle is 55mm longer through the tool changer
  • Diameter of tool changer: 59mm
Delivery Content: 
Tool changer fitting Kress FME and quick installation manual
The tool holder is not included. 
To operate the tool changer you will need 2 Electro-pneumatic valves 3 / 2 to control the air 
for switching and for the blow-out
Manuals and Instructions