Tool Changer for all DC Air Cooled Spindles with 52mm diameter

Product code: 14-0347

Weight: 0.700 Kg

€ 399,00

VAT is not included (24%)

        Readily available
Show shipping cost estimation
Tool Changer for all DC Air Cooled Spindles
This spindle is suitable for all DC Air cooled Spindles. The assembly is quick and very simple. 
It is screwed onto the spindle shaft and attached to the spindle. 
Then you can fasten the "tool change spindle" just like the original 
DC spindle with the 52mm mount.

The tool sits in a SK15 tool holder (in a ER11 collet) 
The SK15 Holder is held with spring force in the cone.
A pneumatic cylinder  presses the tool holder out of the cone.

  • Aluminum case 7075, hard-anodized
  • Stainless steel spindle
  • Double ball bearings (Hybrid-Ceramic-bearnngs on request)
  • Concentricity of 0.01 mm 
  • Weight 1.6 Kg
  • Tensile force of the spring 25 Kg
  • Uses SK15 Toolholders for ER11 Collets (1-8mm)
  • Operating pressure 8 bar
  • 1 pneumatic connectors for 6mm Tubing
  • Fastening with 52mm mount
  • Suitable for speeds up to 3000 rpm
  • Diameter of tool changer: 52mm
Delivery Content: 
Tool Changer for all DC Air Cooled Spindles

The tool holder is not included.
The 300W DC Spindle is not included.
To operate the tool changer you
will need 1 Electro-pneumatic valves 3 / 2 to control the air 
for switching and for the blow-out