Αισθητήρας για την μέτρηση εργαλείου 24mm

Κωδικός προϊόντος: 14-0222

Βάρος: 0.048 Kg


€ 39,84


Οι τιμές δεν περιλαμβάνουν ΦΠΑ (24%)


        Διαθεσιμότητα (7-14 days)
Show shipping cost estimation
Περιγραφή
Wire Material
Copper 
Diameter
35 mm
Thickness
20mm
Effective Surface Diameter
25mm
Weight
53g
 
Connect the wire of this tool check instrument to the tool connector of your Control board of the machine ,then the control boards GND connect to the frame of your router ( the frame of the router and the spindle must have connections).
-If your interface board has the limit switch port or other probe port, you can connect it to that port
-If your interface board does not have that port, your driver board has that port, you can connect it to the driver boards limit switch port
-Then in the Mach3 , you need to setup
the probe (Mach3 --- Config---Ports and Pins---Input signals Probe enabled , the pin number type the one you use) and the Auto-Tool-Zero. In the attachment, it is the code, you can edit it as your requirements.